Installation path: /usr/lib/python3.9/site-packages/rivalcfg r, -reset Reset all settings to their factory default b BUTTONS_MAPPING, -buttons BUTTONS_MAPPINGīuttons(button1=button1 button2=button2 īutton3=button3 button4=button4 button5=button5 Set the light effect (values: rainbow-shift,īreath-fast, breath, breath-slow, steady, rainbow. e LIGHT_EFFECT, -light-effect LIGHT_EFFECT c LOGO_COLOR, -logo-color LOGO_COLOR, -z4 LOGO_COLOR Set the color of the bottom LED of the strip (e.g. strip-bottom-color Z3_COLOR, -z3 Z3_COLOR Set the color of the middle LED of the strip (e.g. strip-middle-color Z2_COLOR, -z2 Z2_COLOR Set the color of the top LED of the strip (e.g. p POLLING_RATE, -polling-rate POLLING_RATE Set sensitivity preset (DPI) (up to 5 settings,įrom 200 dpi to 8500 dpi, default: '800, 1600') Keep in mind that LOD may vary slightly depending on the mousing surface (pad) it is being used on.-s SENSITIVITY, -sensitivity SENSITIVITY The only available (default) setting is high as it does track at a height of 2 DVDs, but not at a height of 3 DVDs. Lift-off DistanceThe Rival 3 does not support adjusting LOD. Furthermore, there is no sensor lens rattle. Finally, at 8500 CPI, jitter is very high. At 3500 CPI, jitter is increased, but still under control, and at 3600 CPI, where smoothing is first applied, it is only marginally reduced. As you can see, no issues with angle snapping can be observed at any of the tested CPI steps. This time around, I'm testing four CPI values: 1600 CPI as a general use baseline 3500 CPI as the highest CPI step without any smoothing 3600 CPI as the first CPI step with smoothing and 8500 CPI as the highest CPI step with smoothing. This test is used to indicate any potential issues with angle snapping (non-native straightening of linear motion) and jitter, along with any sensor lens rattle.
0 kommentar(er)
